Table of Contents
Advertisement
iLS600, iLS600-R and iLS1500 Series
APPENDIX
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude] <MIN|MAX| value>
— This
command sets the Current setpoint as specified. The setpoint can be set to MIN (0.0
amperes), MAX (model-specific maximum current), or a specified value, in amperes. DEF is
accepted but ignored.
[SOURce:]CURRent[:LEVel][:IMMediate][:AMPLitude]?
— This command returns the
present Current setpoint, in amperes.
[SOURce:]CURRent:PROTectection[:LEVel] <value>
— This command sets the over-
current protection threshold to value, which is specified in amperes. Note: If storage of this
threshold to non-volatile memory is desired, SYSTem:CONFiguration:SAVE must also be
executed.
[SOURce:]CURRent:PROTectection[:LEVel]?
— This command returns the present over-
current protection threshold, in amperes.
[SOURce:]POWer[:LEVel][:IMMediate][:AMPLitude] <MIN|MAX|value>
— This command
sets the Power setpoint as specified. The setpoint can be set to MIN (0.0 watts), MAX
(model-specific maximum power), or a specified value, in watts.
[SOURce:]POWer[:LEVel][:IMMediate][:AMPLitude]?
— This command returns the
present Power setpoint, in watts.
[SOURce:]POWer:PROTectection[:LEVel] <value>
— This command sets the overpower
protection threshold to value, which is specified in watts. Note: If storage of this threshold to
non-volatile memory is desired, SYSTem:CONFiguration:SAVE must also be executed.
[SOURce:]POWer:PROTectection[:LEVel]?
— This command returns the present over-
power protection threshold, in watts.
[SOURce:]VOLTage[:LEVel][:IMMediate][:AMPLitude] <MIN|MAX| value>
— This
command sets the Voltage setpoint as specified. The setpoint can be set to MIN (0.0 volts),
MAX (model-specific maximum voltage), or a specified value, in volts. DEF is accepted but
ignored.
advancedenergy.com
45
Rev. 05.20.21_#1.0
Advertisement
Table of Contents
