Table of Contents
Advertisement
2. Remove the four screws from the drive.
Removing the Screws from the Half-Height Drive
3. Place the drive cage over the half-height drive.
4. Attach the drive cage to the half-height drive by loosely
replacing the four screws that you removed from the half-
height drive. Insert the screws through the drive cage and into
the half-height drive.
Two sets of screw holes are provided on each side of the
NOTE:
drive cage. Select the pairs of holes that match the holes in the
sides of the half-height drive.
Attaching the Drive Cage to the Half-Height Drive
Installing and Removing a Half-Height Bay Device 10-9
Advertisement
Table of Contents
