4. Replace the drive cage shield by inserting the four tabs along
the back of the drive cage shield into the four slots on the
metal plate.
5. Replace the three screws that secure the drive cage shield to
the expansion base. The two matching screws go into the
outside rails. Ensure that the right screw 1 secures the
grounding strap grommet 2 to the drive cage shield.
Replacing the Screws in the Drive Cage Shield
6. To complete the reassembly of the expansion base, refer to
"Installing a Half-Height Bay Device" in this chapter and
follow the instructions in these sections:
First, "Replacing the Top Cover."
Second, "Replacing the Rear Panel."
Installing and Removing a Half-Height Bay Device 10-19