Table of Contents
Advertisement
3. Place the computer left side down on the docking rail
the tower stand. The weight of the computer should close the
hinged panel
and hold it firmly
If the hinged panel does not close completely, raise the
width selector.
If the hinged panel closes but does not hold the computer
firmly against the expansion base, lower the width selector.
Hinged Panel Closing Flush Against the Computer
4. To confirm that the width of the tower stand is set correctly,
slide the computer toward the rear of the expansion base. The
width setting is correct if
The docking connector on the computer aligns with the
docking connector on the expansion base.
The motorized docking mechanism activates when the
docking connectors come into contact.
11-8 Setting Up a Tower System
of the tower stand flush against the computer
against the desktop expansion base.
of
Advertisement
Table of Contents
