Table of Contents
Advertisement
4. Place the computer left side down on the docking rail
the tower stand. If the preset width of the tower stand is
the correct setting for your computer, the weight of the
computer will close the hinged panel
the computer.
NOTE:
If the hinged panel does not close flush against the top
of the computer, refer to "Adjusting the Width of the Tower
Stand," next in this chapter.
5. Slide the computer toward the rear of the expansion base until
the docking connector on the computer
with the docking connector on the expansion base
activates the motorized docking mechanism, which pulls the
computer into a fully seated connection.
Sliding the Computer into the Desktop Expansion Base
flush against the top of
comes into contact
Setting Up a Tower System 11-5
of
. This
Advertisement
Table of Contents
