Replacing the Rear Panel
To replace the rear panel, follow these steps:
1. Replace the rear panel by inserting the tabs on the top of the
rear panel into the slots in the top cover. When the tabs are in
the slots, pivot the bottom of the rear panel downward until it
is seated.
2. Secure the rear panel by moving the rear panel release latch
right to the closed position.
3. Reconnect the power cord and all external equipment cables to
the expansion base.
Accessing Expansion Board Connectors
Once an expansion board is installed in the top 1 or bottom 2
slot, you can access its connectors from the right side of the
expansion base.
Accessing an Expansion Board Connector
If the expansion board that has been installed has a cable, refer to
the documentation included with the expansion board for
connection information.
9-8 Installing and Removing an Expansion Board