Removing A Half-Height Bay Device - HP Armada 7300 Installation And Operation Manual

Removing a Half-Height Bay Device

This procedure explains how to remove a standard half-height
drive from the half-height bay. The procedures for removing an
Armada 7000 Half-Height MultiBay Adapter or an LTE 5000
Half-Height MultiBay Adapter are similar. Refer to the adapter
documentation for specific instructions.
Use slotted Torx T-10 and T-15 screwdrivers.
NOTE:
Accessing the Half-Height Bay Device
To access the half-height bay device, refer to "Installing a Half-
Height Bay Device" earlier in this chapter and follow the
instructions in these sections:
First, "Before You Begin."
Second, "Removing the Rear Panel."
Third, "Removing the Top Cover."
Removing the Drive Cage Assembly
To remove the drive cage and half-height drive, follow
these steps:
1. After you have removed the top cover, remove the three
screws securing the metal drive cage shield to the
expansion base.
Removing the Screws from the Drive Cage Shield
Installing and Removing a Half-Height Bay Device 10-15