Table of Contents
Advertisement
Removing the Drive Cage
To remove the drive cage, follow these steps:
1. Remove and retain the three screws securing the metal drive
cage shield to the expansion base. The screws are two sizes.
Removing the Screws from the Drive Cage Shield
2. Lift the front edge of the metal drive cage shield and swing it
approximately 45 degrees upward. Then pull it toward you.
The shield pivots along the four tabs extending into the metal
plate at the rear of the drive cage shield.
Removing the Drive Cage Shield from the Desktop Expansion Base
Installing and Removing a Half-Height Bay Device 10-7
Advertisement
Table of Contents
