MacDon M155 Unloading And Assembly Instructions page 7

Section
3.19.1 Removing Windrower from Factory
Stand, page 88
• Step
2, page 88
4.2 Cab Display Options, page 91
4.2.1 Setting the Cab Display Language, page
91
• Step
5, page 92
4.3 Configuring the Windrower, page 97
4.3.1 Setting the Header Knife Speed, page 97
4.3.2 Setting the Knife Overload Speed, page
98
4.3.3 Setting the Rotary Disc Overload Speed,
page 99
4.3.4 Setting the Hydraulic Overload Pressure,
page 100
4.3.5 Setting the Header Index Mode, page
101
4.3.6 Setting the Return to Cut Mode, page
101
4.3.7 Setting the Auto Raise Height, page 102
4.3.10 Setting the Header Cut Width, page
105
4.3.11 Activating the Swath Compressor, page
106
4.3.15 Setting the Engine Intermediate Speed
Control rpm, page 111
• Figure
4.48, page 111
4.3.15 Setting the Engine Intermediate Speed
Control rpm, page 111
• Figure
4.48, page 111
4.3.16 Clearing Sub-Acres, page 112
215015
Summary of Change
ignition before leaving the operator's seat for
any reason.
Added CAUTION:
• Park on a flat, level surface with the ground
speed lever in N-DETENT position and the
steering wheel in locked position (centered).
Wait for the CDM to beep and display an "In
Park" message to confirm the park brakes
have engaged.
Revised step and picture to show all lift lock
mechanisms.
Moved topic. Was chapter 4.5.
Revised NOTE.
Moved topic. Was chapter 4.2
Added topic introduction.
Added topic introduction.
Added topic introduction.
Added topic introduction.
Added topic introduction.
Added topic introduction.
Added topic introduction.
Added metric conversions of header sizes and cut
widths.
Added swath compressor topic.
• Added topic introduction.
• Revised picture.
Corrected callouts, or removed unnecessary
callouts from picture.
Added topic introduction.
v
Internal Use Only
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Tech Pubs
Revision A