Table of Contents
Advertisement
4.3 Learn and Test IR Commands
Follow the steps below and Fig. 4-6 to learn and test IR commands:
[1] Determine the IR command for learning by selecting the items in the "Device Name"
and "Command Name" combo boxes.
[2] Click the "Learn On" button to enable the IR learning mode on IR-712A. At the same
time, the TR/LN LED is turned on to show the IR learning state.
[3] Aim the IR emitter head of the device's remote control at the IR input of IR-712A. The
distance less than 3 cm between the remote control and the IR-712A would be best.
Then, press the button of the remote control which is to be learned in a short time. If
the learning for the IR command is finished, the TR/LN LED will be turned off and the
IR learning data will be sent back to the Utility.
[4] Select the IR output channel. For example in fig. 4-6, the IR output channel is 1.
[5] Aim the head of the IR emitter cable plugged in the IR output 1 at the corresponding
IR-controlled device. Click "Run Command" button to emit the IR command from the
IR-712A. You can check if the learned IR command is OK by investigate the action
of the appliance. If not, please repeat step 2 and step 3 again.
[6] Click "Save this Cmd" button to save this IR learning command to the current item of
the "Command Name" combo box, e.g. the item is "Play" in figure 4-6.
Repeat the above steps to learn all the IR commands.
IR-712A User Manual
Copyright © 2021 ICP DAS Co., Ltd. All Rights Reserved
Version 1.9
E-mail: service@icpdas.com
41
Page：
Advertisement
Table of Contents
