Emit Ir Commands Section - ICP DAS USA IR-310-RM User Manual

ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7(495)109-02-08 sales@bbrc.ru www.bbrc.ru

4.2.8 Emit IR Commands section

Custom and built-in IR commands are available for IR remote control on the IR-310-
RM. Each IR command is for an IR-310-RM with specific Modbus Net ID and the
corresponding IR-relay-state configured in the section of Relay States Corresponding
to IR cmds (Section 4.2.9).
Plug the IR emitter cable CA-IR-SH2251-5 in the jack of IR Output at the rear of the
IR-310-RM. Click the "Emit IR Command" button will emit an IR command. Users can
aim the head of the IR emitter cable to the IR receiver of the IR-310-RM for test. This
function is for the IR learning remote to learn the IR commands for the IR-310-RM
module.
(1) Custom IR commands
‧Nons equential mode
IR cmd #
0 ~ 63 The IR commands corresponding to customizable 10 relays states.
(Refer to 4.2.9)
192 ~ 223 32 IR commands corresponding to the built-in relay states. (Appendix A)
‧Sequential mode
IR cmd #
0 Stop the forward/backward sequential action.
1 Have 10 relays move forward to NO sequentially.
2 Have10 relays move backward to NC sequentially.
3 ~ 63 IR commands corresponding to customizable 10 relays states.
(Refer to 4.2.9)
192 ~ 223 IR commands corresponding to the built-in relay states. (Appendix A)
IR-310-RM, IR Controlled 10-ch High Power Relay Module (Ver. 1.1, Jul/02/2013) 26
Figure 4-9: Emit IR commands for learning..
Description
Description