Set The Devices And Ir Commands Quantity - ICP DAS USA IR-712A User Manual

4.2 Set the Devices and IR commands Quantity

Click the "Set Device & IR Command Quantity" button at top-right corner (Fig. 4-2) to open the
configuration dialog. Follow three steps below to finish the configuration of the devices and IR
commands quantity in advance of the next IR learning.
 Step 1 : Set the quantity of the IR-controlled devices as shown in Fig. 4-3.
 Step 2 : Set the device name and the quantity of the IR commands as the Fig. 4-4.
 Step 3 : Set the IR command names as depicted in Fig. 4-5.
The prefix numbers of these IR command names (e.g. 1_Play) represent the numbers of 224 IR
commands saved in the IR-712A module. They will be used as IR command number in the
Modbus command for communication with IR-712A.
 Figure 4-2 The button for configuration of IR command quantity.
 Figure 4-3 Set device quantity.  Figure 4-4 Set device names & IR cmd quantity.
IR-712A User Manual
Copyright © 2021 ICP DAS Co., Ltd. All Rights Reserved
 Figure 4-5 Set names of IR commands.
Version 1.9
E-mail: service@icpdas.com
40
Page：