Self-Test - ICP DAS USA ECAT-201x EtherCAT Slave I/O User Manual

ECAT-2011H EtherCAT Slave I/O module

3.3 Self-Test

This chapter can give you the detail steps about self-test. In this way, user can confirm that
ECAT-2011H/2012H well or not. Before the self-test, you must prepare a stable signal source (e.g.,
dry battery) is available, and than follow the steps described below:
 Wire the stable signal source (e.g., dry battery) to AI channel 0.
 ECAT-2011H/2012H connect the V0- (Pin01) to signal positive(-), ECAT-2016N connect the VIn-
(Pin14) to signal positive(-).
 ECAT-2011H/2012H connect the V0+ (Pin02) to signal positive(+),ECAT-2016N connect the VIn+
(Pin11) to signal positive(+).
 
Dry Battery Dry Battery

(-) 
(+)

(+)

(-)
Figure 3-3.1
Copyright © 2019 ICP DAS CO., Ltd. All Rights Reserved. - 23 -