Page 1
Modules have a screw-terminal block to connect to the signals. I-7016 comes with FREE EZ Data Logger Software. 2. Terminal Assignment I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com...
Page 2
3. Block/ Wiring Diagram I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717...
3. Connect the module to the power supply using the +Vs and GND terminals. Note that the voltage supplied should be in the range of +10 to +30V DC. I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com...
Page 4
The default settings for the module can be found in Section 3. Click OK after selecting the COM port setting. I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com...
Page 5
DCON Utility Pro supports DCON and Modbus protocol for all ICPDAS and the others modules. 6. Configuration I/O module setting on PC I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com...
Page 6
Section 2 for details. Read data from the input channels: send either the #AA or #AAN command to the module. I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com | 1-310-517-9888 | 24309 Narbonne Ave. Suite 200. Lomita, CA 90717...
Page 7
If user doesn’t know command, user can select Address and ID, it will show some refer commands as below. User can select necessary command to test or debug modules. I-7016D - Strain Gauge Voltage Input, Current Input DAQ Module - QuickStart (Nov/2017) ICP DAS USA, Inc. | www.icpdas-usa.com...