Datalogic Cobalto CO5330 Product Reference Manual page 231

1. Determine the desired setting in milliseconds.
2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with
3. Scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Programming Mode.
4. Go to
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit.
This completes the procedure. See the following table for examples of how to set this feature.
Table 6. Intercharacter Delay Setting Examples
STEP ACTION
1 Desired Setting
Divide by 10 (pad with
2 leading zeroes to yield two-
digits)
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
Product Reference Guide
leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.
page 23
and scan the bar code: SELECT INTERCHARACTER DELAY SETTING.
duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to
abort and not save the entry string. You can then start again at the beginning.
NOTE
50ms
05
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCHARACTER DELAY SETTING
'0' and '5'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
EXAMPLES
150ms 600ms
15 60
'5' and '0' '6' and '0'
RS-232 Parameters
Keypad, that represent the
850ms
85
'8' and '5'
219