Datalogic Cobalto CO5330 Product Reference Manual page 25

Resetting the Product Configuration to Defaults
If you aren' t sure what programming options are in your scanner, or you've changed some
options and want to restore the Custom Default Configuration that may have been saved in
the scanner, scan the
the custom configuration for the currently active interface.
If you aren' t sure what programming options are in your scanner, or you've changed some
options and want to restore the Factory Configuration, you have two options. You can scan the
Restore USA Factory Configuration
below. Both labels restore the scanner configuration to the factory settings including the
interface type. The USA label restores Label IDs to those historically used in the USA. The EU
label restores Label IDs to those historically used in Europe. The Label ID sets for USA and EU
are shown in the Label ID section of this manual.
CAUTION
The programming section on the following pages lists the factory default settings for each of
the menu commands (indicated by shaded blocks and bold text).
Product Reference Guide
Restore Custom Default Configuration
Custom defaults are based on the interface type. Configure the scanner for the
correct interface before scanning this label.
NOTE
Restore Custom Default Configuration
Scanning either of the "Restore Factory Configuration" commands below will
result in the loss of any custom configuration settings for your device.
Restore USA Factory Configuration
Restore EU Factory Configuration
Customizing Configuration Settings
bar code or the Restore EU Factory Configuration
bar code below. This will restore
bar code
13