Indicate Transmission Failure; Disable Character - Datalogic Cobalto CO5330 Product Reference Manual

Enter/Exit Programming Mode

Indicate Transmission Failure

This option enables/disables the scanner's ability to sound an error beep to indicate a
transmission failure while in ACK/NAK mode
$CR2TF01
Indicate Transmission Failure = Enable Indication

Disable Character

Specifies the value of the RS-232 host command used to disable the scanner.
ASCII characters or any hex value from 0 to 0xFF can be selected. See
page 224
$CR2DC
Select Disable Character Setting
30

for more detailed programming instructions.
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters.
NOTE
DEFAULT
.
Indicate Transmission Failure = Disable Indication
0x44 = Disable Character is 'D'
Indicate Transmission Failure
$CR2TF00 
DEFAULT
"Disable Character" on
Cobalto™ CO5300 Scanner