Intercode Delay - Datalogic Cobalto CO5330 Product Reference Manual

References

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The selectable
range for this feature is from 0 to 99 seconds.
Follow these instructions to set this feature:
1. Determine the desired setting.
2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 =
3. Go to
4. Scan the bar code: SELECT INTERCODE DELAY SETTING.
5. Scan the appropriate two digits from the keypad in
6. Scan the ENTER/EXIT PROGRAMMING MODE bar code to exit Programming Mode.
This completes the procedure. See the table below for examples of how to set this feature.
Table 15. Wedge Intercode Delay Examples
STEP ACTION
1 Desired Setting
2 Pad with leading zero(es)
3
4
Scan Two Characters From
5
Appendix D, Keypad
6
228
20, etc
page 41 and scan the ENTER/EXIT PROGRAMMING MODE bar code to enter Pro-
gramming Mode.
duration which was determined in the steps above. You will hear a two-beep indication
after the last character.
If you make a mistake before the last character, scan the CANCEL bar code to
abort and not save the entry string. You can then start again at the begin-
ning.
NOTE
No Delay
00
Scan ENTER/EXIT PROGRAMMING MODE
Scan SELECT INTERCODE DELAY SETTING
'0' and '0'
Scan ENTER/EXIT PROGRAMMING MODE
Appendix D,
EXAMPLES
5 Seconds 60 Seconds
05 60
'0' and '5' '6' and '0'
Cobalto™ CO5300 Scanner
Keypad, that represent the
99 Seconds
99
'9' AND '9'