Enter/Exit Programming Mode
Codablock F Set Length 2
This feature specifies one of the bar code lengths for
is the maximum label length if in
Length
length does not include start/stop characters.
The length can be set from 3 to 255 characters. A setting of 00 specifies to ignore this length
(only one fixed length). See
instructions.
Select Codablock F Length 2 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
198
Mode. Length includes the bar code's check, data, and full-ASCII shift characters. The
"Set Length 2"
$CCFL2
DEFAULT
Codablock F Length Control
Variable Length
Mode, or the second fixed length if in
on page 241 for more detailed programming
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
100 = Length 2 is 100 Characters
Codablock F
. Length 2
Appendix D,
~
CANCEL
Cobalto™ CO5300 Scanner
Fixed