Table of Contents
Advertisement
References
Label ID: Set Individually Per Symbology
To configure a Label ID individually for a single symbology:
1. Scan the ENTER/EXIT bar code.
2. Select Label ID position as either BEFORE (Enable as Prefix) or AFTER (Enable as suffix)
3. Scan a bar code to select the symbology for which you wish to configure a custom Label
4. Determine the desired character(s) (you may choose up to three) which will represent the
5. Turn to the
NOTE
6. Scan the ENTER/EXIT bar code to exit Label ID entry.
7. Scan the ENTER/EXIT bar code once again to exit Programming Mode.
This completes the steps to configure a Label ID for a given symbology.
Figure 6. Label ID Position Options
234
by scanning the appropriate bar code in the section
Figure 6
for Label ID positioning options if multiple identification features are enabled.
ID from the section
Label ID Symbology Selection, starting on page
Label ID for the selected symbology.
ASCII Chart
on the inside back cover of this manual and find the equivalent hex
digits associated with your choice of Label ID. For example, if you wish to select an equal
sign (=) as a Label ID, the chart indicates its associated hex characters as 3D. Turn to
Keypad, starting on page 267
mined. For the example given, the characters '3' and 'D' would be scanned. More exam-
ples of Label ID settings are provided in
If you make a mistake before the last character, scan the CANCEL bar code to
abort and not save the entry string. You can then start again at the begin-
ning.
Prefix
Label ID
Aim ID
and scan the bar codes representing the hex characters deter-
Table
17.
Bar Code Data
OR
"Label ID Control" on page
49. Reference
50.
Label ID
Suffix
Cobalto™ CO5300 Scanner
Advertisement
Chapters
Table of Contents
