Standard Factory Settings
The programming bar codes in this chapter allow modifications to the standard RS-232 and
USB-Com interfaces.
Standard Factory Settings
Reference
Intercharacter Delay
This parameter specifies the intercharacter delay between the end of one character and the
beginning of the next. The delay can be set within a range of zero (0) to 990 milliseconds in
10ms increments. A setting of zero specifies no delay. See
page 232
Select Intercharacter Delay Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
Product Reference Guide
RS-232/USB-COM Interfaces
Appendix B, Standard Defaults
for more detailed programming instructions.
$CR2IC
DEFAULT
for a listing of standard factory settings.
"Label ID: Pre-loaded Sets" on
Intercharacter Delay = No Delay
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig-
its from the Alphanumeric characters in
Keypad
representing your desired character(s). End
by scanning the ENTER/EXIT bar code again.
00 = No Intercharacter Delay
Enter/Exit Programming Mode
$CR2IC00
Appendix D,
~
CANCEL
23