Parallel Input/Output Unit - Mitsubishi MELFA RV-6S Series Standard Specifications Manual

3Controller

3.9 Parallel input/output unit

・ A parallel input/output unit or card is mounted as a standard in the controller's control unit.
・ The external input/output circuit specifications are shown in
・ The correspondence of the external input/output connector pin No. and the colors of the connected "external
input/output cable" wires (separate option) is as shown in
81, "(4) External I/O cable"
・ Pin Nos. described as both general-purpose signal and dedicated signal can be shared.
・ The other dedicated input/output signals that are not assigned can be assigned to required general-purpose
input/output pins when creating the program.
・If the standard inputs and outputs are insufficient, install the parallel input/output unit connection option outside
the controller.
Table 3-6 ： Electrical specifications of input circuit
Item
Type
No. of input points
Insulation method
Rated input voltage
Rated input current
Working voltage range
ON voltage/ON current
OFF voltage/OFF current
Input resistance
OFF-ON
Response time
ON-OFF
Common method
External wire connection
method
Table 3-7 ： Electrical specifications of output circuit
Item
Type
No. of output points
Insulation method
Rated load voltage
Rated load voltage range
Max. load current
Leakage current at OFF
Max. voltage drop at ON
OFF-ON
Response time
ON-OFF
Fuse rating
Common method
External wire connection
method
Voltage
External power
supply
Current
Parallel input/output unit
3-58
for details of external I/O cable.
Specifications
DC input
32
Photo-coupler insulation
12VDC/24VDC
Approx. 3mA/approx. 7mA
10.2VDC to 26.4VDC(ripple rate within 5%)
8VDC or more/2mA or more
4VDC or less/1mA or less
Approx. 3.3kΩ
10ms or less(DC24V)
10ms or less(DC24V)
8 points per common
Connector
Specifications
Transistor output
32
Photo-coupler insulation
DC12V/DC24V
DC10.2 ～ 30V(peak voltage 30VDC)
0.1A/point (100％)
0.1mA or less
DC0.9V(TYP.)
2ms or less
(hardware response time)
2ms or less
(Resistance load) (hardware response time)
Fuse 3.2A (one per common) Replacement not pos -
sible
8 points per common (common terminal: 8 points)
Connector
DC12/24V(DC10.2 ～ 30V)
60mA (TYP. 24VDC per common)
(base drive current)
Table 3-6 and Table 3-7.
Page 61, "Table 3-8"and
<Sink type>
<Source type>
<Sink type>
<Source type>
Table 3-9. Refer to Page
Internal circuit
24V/12V
(COM)
820
Input
3.3K
3.3K
Input
820
0V(COM)
Internal circuit
(24/12V)
Outline
(0V)
Fuse
Fuse (24/12V)
Outline
(0V)