Table of Contents
Advertisement
3.7 Additional Axis Function (CR3-535M controller only)
The CR3-535M controller is equipped with an additional axis interface for controlling an additional axis when a
traveling axis or rotary table is added to the robot. A maximum of eight axes of servo motors can be controlled at
the same time by connecting a general-purpose servo amplifier (MR-J2S-B, MR-J2M series) that supports Mit -
subishi's SSC Net.
Refer to the separate "Additional axis interface Instruction Manual" for details on the additional axis function.
3.7.1 Wiring of the Additional Axis Interface
Table 3-4
shows the connectors for additional axes inside the controller and
(configuration example). The magnet contactor control connector for additional axes, AXMC1, is designed to
accommodate circuit connection with improved safety in Mitsubishi's industrial robot systems connecting addi -
tional axes. Please implement the appropriate circuit connection by refere to
control connector output (AXMC) for addition
Table 3-4 ： Dedicated Connectors inside the Controller
Name
Connector for additional axes
Magnet contactor control connector
for additional axes
Note1) The CN1A connector has already been in use.
Control unit
(R6x2CPU)
AXMC1 connector
Table 3-5 ： Connection Example of Additional Axis Interface Connection (Configuration Example)
Connector name
Note1)
CN1B
AXMC1
Control unit
(R6x2CPU)
Bus cable between
controller and amplifier
CN1B connector CN1A connector
axes".
This connector is used to connect between general-purpose servo
amplifiers and the controller.
This contact output is used to turn ON/OFF the motor power by
connecting to general-purpose servo amplifiers.
CN1A connector
CN1B connector
Servo amplifier
Bus cable between amplifiers
CN1B connector
Illegible
Additional Axis Function (CR3-535M controller only) 3-55
Fig. 3-5
shows a connection example
Page 56, "3.8 Magnet contactor
Details
Servo amplifier
CN1A connector
3Controller
Terminator
CN1B connector
Advertisement
Table of Contents
