Switching The Thread Colors On The Screen - Brother PR670E Operation Manual

Switching the Thread
Colors on the Screen
If a thread color on the spool stand is different than
the needle position thread color on the screen, the
thread colors on the screen can be switched to
match the spool stand thread color position.
Memo
• This function is not available when you set
"Manual Color Sequence" to "ON" in
settings screen.
a Touch in the embroidering screen.
 The spool selection screen appears.
b Touch the number of the first needle bar
that will be switched.
• To cancel the selection, touch the same needle
number again.
c Touch the number of the other needle bar
that will be switched. The two needle
numbers are connected with an arrow.
• To cancel the selection, touch the same needle
number again.
OTHER BASIC PROCEDURES
d Touch to switch the two thread
colors.
e After making the desired changes, touch
.
■ To cancel the thread color settings
for all previously stitched design
Memo
• The color settings will be completely
canceled even if the machine is in the
middle of the embroidery.
a Touch .
 The thread color setting is canceled.
b Touch .
 Thread colors are assigned by the machine again,
regardless of the previous spool setting.
Note
• This function will not clear anchor settings
of any of the needles which have been
assigned a thread color (Refer to "Reserved
Needle Bar and Sewing Speed Settings" on
page 120).
3
93