Power State Commands - SMART Board SBID-7275R Installation And Maintenance Manual

Appendix B
Managing the display using RS-232
To assign a value to a setting
Use a set command.
This example sets the volume to 65:
>set volume=65
volume=65
>
To increase or decrease the value of a setting
Use the set command to increase or decrease the value by a designated number.
This example increases the volume by 5:
>set volume+5
volume=70
>
This example decreases the volume by 15:
>set volume-15
volume=55
>

Power state commands

Get command
get powerstate
smarttech.com/kb/171538
Set command
set powerstate[Value]
Where [Value] is one of the following:
=on
l
=ready
l
=standby
l
NOTE
If the display is in UPDATEON or
UPDATEREADY state, it might not
change power states after receiving the
command.
Response
powerstate=[Value]
Where [Value] is one of the following:
on
l
ready
l
standby
l
update
l
74