Power State Commands - SMART Board SBID-MX055-V3N-PW Installation And Maintenance Manual

Appendix C Managing SMART Board MX (V3, V2, and V2-C) series displays using RS-232
To increase or decrease the value of a setting
Use the set command to increase or decrease the value by a designated number.
This example increases the volume by 5:
>set volume+5
volume=70
>
This example decreases the volume by 15:
>set volume-15
volume=55
>

Power state commands

Get command
get powerstate
smarttech.com/kb/171555
Set command
set powerstate[Value]
Where [Value] is one of the following:
=on
l
=ready
l
=standby
l
=powersave
l
Notes
If the display is in UPDATEON or
l
UPDATEREADY state, it might
not change power states after
receiving the command.
When switching between power
l
states on displays running iQ 3.11
or earlier, wait at least 30
seconds before sending another
command.
Response
powerstate=[Value]
Where [Value] is one of the following:
on
l
ready
l
standby
l
powersave
l
updateon
l
updateready
l
103