Important Information - SMART Board SBID-7275R Installation And Maintenance Manual

Important information

STABILITY HAZARD
If not installed properly, this display may fall causing serious
injury or death. To prevent injury, the display must be securely
attached to the wall following the installation instructions.
WARNING
Failure to follow the installation instructions included
l
with the display could result in injury and product
damage which may not be covered by the warranty.
Do not open or disassemble the display. You risk
l
electrical shock from the high voltage inside the casing.
Opening the casing also voids the warranty.
Do not stand (or allow children to stand) on a chair to
l
touch the surface of the display. Rather, mount the
product at the appropriate height.
To reduce the risk of fire or electric shock, do not
l
expose the display to rain or moisture.
If the display requires replacement parts, make sure the
l
service technician uses replacement parts specified by
SMART Technologies or parts with the same
characteristics as the original.
Ensure that any cables that cross the floor to the display
l
are properly bundled and marked to avoid a trip hazard.
Do not insert objects inside the cabinet ventilation
l
holes, because they could touch dangerous voltage
points and cause electric shock, fire, or product damage
which may not be covered by the warranty.
Do not place heavy objects on the power cable.
l
Damage to the cable could cause shock, fire, or product
damage which may not be covered by the warranty.
Use only extension cords and outlets that can fully
l
accommodate the display's polarized plug.
Use the power cable provided with the display. If a
l
power cable is not supplied, contact your supplier. Use
only power cables that match the AC voltage of the
power outlet and that comply with your country's safety
standards.
If the glass is broken, do not touch the liquid crystal. To
l
prevent injury, handle glass fragments with care when
disposing of them.
Do not move or mount the display by connecting rope or
l
wire to its handles. The display is heavy, and failure of
the rope, wire, or handle could lead to injury.
smarttech.com/kb/171538
Use only VESA-approved mounts.
l
Disconnect all of the display's power cables from the
l
wall outlet and seek assistance from qualified service
personnel if any of the following occur:
The power cable or plug is damaged
o
Liquid is spilled into the display
o
Objects fall into the display
o
The display is dropped
o
Structural damage, such as cracking, occurs
o
The display behaves unexpectedly when you
o
follow operating instructions
CAUTION
Turn off the display before cleaning its screen.
l
Otherwise, you may scramble the desktop icons or
inadvertently activate applications when you wipe the
screen.
Avoid setting up and using the display in an area with
l
excessive levels of dust, humidity, and smoke.
Make sure an electrical socket is near the display and
l
remains easily accessible during use.
The display should be used only with European TN and
l
TT power distribution systems.
It is not suitable for older, IT-type power distribution
systems found in some European countries. "This
system (IT-type) is widely used isolated from earth, in
some installations in France, with impedance to earth, at
230/400V, and in Norway, with voltage limiter, neutral
not distributed, at 230V line-to-line."
Contact qualified personnel if you're uncertain of the
type of power system available where you're installing
the display.
The accessory slot's maximum available power is 60 W.
l
The slot is not a limited power source. To reduce the risk
of fire, make sure that accessories connecting to the slot
satisfy the fire enclosure requirements of IEC 60950-1
and/or IEC 62368-1.
You must connect the USB cable that came with the
l
display to a computer that has a USB compliant
interface and that bears the USB logo. In addition, the
USB source computer must be compliant with IEC
60950-1 and/or IEC 62368-1. The source computer must
be CE marked and carry safety certification marks for
Canada and USA. This is for operating safety and to
avoid damage to the display.
3