Appendix C Managing the SMART Board 6000S (V3) display using RS-232
To assign a value to a setting
Use a set command.
This example sets the volume to 65:
>set volume=65
volume=65
>
To increase or decrease the value of a setting
Use the set command to increase or decrease the value by a designated number.
This example increases the volume by 5:
>set volume+5
volume=70
>
This example decreases the volume by 15:
>set volume-15
volume=55
>
Power state commands
Get command
get powerstate
smarttech.com/kb/171414
Set command
set powerstate[Value]
Where [Value] is one of the following:
=on
l
=ready
l
=standby
l
=powersave
l
Note
If the display is in UPDATEON or
UPDATEREADY state, it might not
change power states after receiving
the command.
Response
powerstate=[Value]
Where [Value] is one of the following:
on
l
ready
l
standby
l
powersave
l
updateon
l
updateready
l
80