SMART Board SBID-7275R Installation And Maintenance Manual page 5

Important information
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired operation
CAUTION
Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to
operate the equipment.
NOTE
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own
expense.
Restriction
This device is restricted to indoor use when operated in the 5.15
to 5.25 GHz frequency range.
IEEE 802.11b or 802.11g operation of this product in the USA is
firmware limited to channels 1 through 13.
Radiation exposure statement
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20 cm between
the radiator and your body. The PEN can be used with 0 cm
separation distance between the pen and your body.
Innovation, Science and Economic
Development Canada statement
The FCC and ISED registration numbers and warnings can be
found through the Settings screen under the Regulatory tab.
Regulatory IDR775-1
Model:
Regulatory IDR786-1
Model:
smarttech.com/kb/171538
This device complies with ICES-003 of the Innovation, Science
and Economic Development Canada Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
Regulatory PR7-1
Model:
This device complies with Industry Canada's RSS-310. Operation
is subject to the condition that this device must not cause
harmful interference and must accept any interference, including
interference that may cause undesired operation of the device.
98-305kHz: <30dBuV/A @10m
Regulatory IDRMOD1
Model:
This device complies with ICES-003 of the Innovation, Science
and Economic Development Canada Rules. Operation is subject
to the following two conditions:
1. This device may not cause harmful interference, and
2. this device must accept any interference received,
including interference that may cause undesired
operation.
CAUTION
(i) the device for operation in the band 5150–5250 MHz is only
for indoor use to reduce the potential for harmful interference
to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in the
bands 5250–5350 MHz and 5470–5725 MHz shall comply
with the e.i.r.p. limit; and
(iii) the maximum antenna gain permitted for devices in the
band 5725–5825 MHz shall comply with the e.i.r.p. limits
specified for point-to-point and non point-to-point operation
as appropriate.
(iv) Users should also be advised that high-power radars are
allocated as primary users (i.e., priority users) of the bands
5250–5350 MHz and 5650–5850 MHz and that these radars
could cause interference and/or damage to LE-LAN devices.
Radiation exposure statement
This equipment complies with ISED radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20 cm between
the radiator and your body. The PEN can be used with 0 cm
separation distance between the pen and your body.
5