Table of Contents
Advertisement
Chapter 3
Connecting computers and other devices
To view a connected computer's input
1. Connect the computer to the display.
2. Do one of the following:
If iQ is enabled
Tap Input
on the Home screen.
OR
Press Input
on the remote control.
The display shows thumbnails of the devices that are connected to the display's inputs:
A gray thumbnail indicates no device is connected to an input.
o
A blue thumbnail indicates a device is connected to an input but is in Sleep mode.
o
A thumbnail showing a preview screen indicates an active device is connected to an input.
o
TIP
If iQ is disabled and you want a computer's input to appear whenever you wake up the display, tap
the star in the upper-left corner of the computer's thumbnail.
3. Tap the computer's thumbnail.
Setting a connected computer's resolution and refresh rate
The following table presents the recommend resolutions and refresh rates for the display's input sources:
Input source
USB Type-C
HDMI 1
HDMI 2
HDMI 3
HDMI 4
VGA
If possible, set any connected computers to these resolutions and refresh rates. See the connected
computers' operating system documentation for instructions.
smarttech.com/kb/171538
If iQ is disabled
Press the Home button
on the remote control.
Resolution
3840 × 2160
3840 × 2160
1920 × 1080
or the Input button
Refresh rate
60 Hz (YCbCr)
30 Hz (RGB)
60 Hz
60 Hz
35
Advertisement
Chapters
Table of Contents
