Serial Number Commands; Part Number Commands; Asynchronous State Reporting Commands; Factory Reset Commands - SMART Board SBID-7275R Installation And Maintenance Manual

Appendix B
Managing the display using RS-232

Serial number commands

Get command
get serialnum

Part number commands

Get command
get partnum

Asynchronous state reporting commands

Get command
get statereporting

Factory reset commands

Set command
set factoryreset=[Value]
Where [Value] is the serial number.
smarttech.com/kb/171538
Response
serialnum=[Value]
Where [Value] is the serial number.
Response
partnum=[Value]
Where [Value] is the part number, including the revision.
Set command
set statereporting[Value]
Where [Value] is one of the following:
=on
l
=off
l
Response
factoryreset=[Value]
Where [Value] is the serial number.
Response
statereporting=[Value]
Where [Value] is one of the following:
on
l
off
l
78