SMART Board SBID-7275R Installation And Maintenance Manual page 75

Appendix B
Managing the display using RS-232
The display has six power states:
Power state Description
ON The display is in normal operating mode.
READY The screen is off, but the display is ready to turn on when one of the following
occurs:
STANDBY The screen is off, and the display is in a low power state. The display enters READY
or ON state when one of the following occurs:
This power state is the default energy saving mode for displays set to a non-EU
location.
NOTE
The EU uses "networked standby" to describe this power state.
POWERSAVE The screen is off, and the display is a very low power state. The display enters
READY or ON state when one of the following occurs:
This power state is the default energy saving mode for displays set to an EU location.
NOTE
The EU uses "standby" to describe this power state.
UPDATEON The display is updating firmware. Do not turn off the display.
UPDATEREADY The display is updating firmware while the screen is off. Do not turn off the display.
With the exception of get powerstate and set powerstate, commands are available only when the
display is in READY or ON power state.
smarttech.com/kb/171538
A user presses the Power button
l
control.
A user picks up a pen or the eraser.
l
You send the set powerstate=on command.
l
The proximity sensors detect people in the room.
l
The proximity sensors detect people in the room.
l
A user presses the Power button
l
control.
You send the set powerstate=ready or set powerstate=on command.
l
A user presses the Power button
l
control.
You send the set powerstate=ready or set powerstate=on command.
l
on the convenience panel or the remote
on the convenience panel or the remote
on the convenience panel or the remote
75