Reset To Factory Defaults; Change Your Login Password; Configure Your Log - TRENDnet TEW734APO User Manual

TRENDnet User's Guide

Reset to factory defaults

You may want to reset your router to factory defaults if you are encountering difficulties
with your router and have attempted all other troubleshooting. Before you reset your
router to defaults, if possible, you should backup your router configuration first, see
"Backup and restore your router configuration settings" on page 70.
There are two methods that can be used to reset your router to factory defaults.

Reset Button – Located on the bottom panel of the access point, cap must be
removed to access reset button. Use this method if you are encountering
difficulties with accessing your router management page. Push and hold this
button for 15 seconds and release to reset your router to its factory defaults.
OR

Router Management Page
Management > Configuration Filet
1. Log into the management page (see
2. Click on Management, and click on Configuration File.
3. You will be prompted to reset your router to factory defaults. Click Yes or OK.
© Copyright 2015 TRENDnet. All Rights Reserved.
Bottom cap remove
"Access the management page" on page 9).

Change your login password

1. Log into the management page (see
2. Click on Management, and click on Password Settings. Click Apply to save changes.
 Current Password: Enter the current password of the access point.
 New Password: Enter the new password
 Confirm Password: Re-enter the new password to confirm.
Note: If you change the login password, you will need to access the management page
using the new password instead of the default password "admin".

Configure your log

You may want send your router log to your e-mail address or to an external log server
(also known as Syslog server) so you can check it periodically while away from home.
You may also want to only see specific categories of logging.
1. Log into the management page (see
2. Click on Tools, and click on System Log. Click Apply to save settings.
 Enable Remote Syslog Server: Check this option to enable DMZ
 IP Address: enter the IP address (e.g. 192.168.10.250) of the external log server
to send
 Port: Enter the port used on your log server.
Email Syslog
TEW-734APO
"Access the management page" on page 9).
"Access the management page" on page 9).
51