FreePort Station User's Manual
Configuring the Transmission Mode
Follow the steps below to configure the transmission mode.
1
Refer to " Installing FreePort Station Manager" to install the FreePort Station Manager.
2
3
When the FreePort Station is set at Full Duplex, make sure that the hub is also set at Full Duplex. When
the FreePort Station is set at Full Duplex Mode and the hub is set at Half Duplex or at Auto Detection, they cannot
communicate with each other.
Resetting FreePort Station Settings to Factory Defaults
1
Power on the FreePort Station.
2
Hold down the "RESET" button located at the rear of the FreePort Station for 3 seconds or longer to reset the
FreePort Station to the factory default settings.
Click Custom Setting.
In the "Communication Mode" field, select either
Full Duplex or Half Duplex and click OK.
20