TRENDnet TEW734APO User Manual page 47

TRENDnet User's Guide
o This is where you enter the password or key needed for a computer to
connect to the router wirelessly
o You can define up to 4 passwords or 4 keys. Only one key can be active at a
given time. Most users simply define one key.
o Choose a key index 1, 2, 3, or 4 and enter the key.
o When connecting to the router, the client must match both the password
and the Key number. (e.g. if you have activated Key 2 with a password of
12345, then the client must select: Key 2 (entering Key 1, 3, or 4 will block
the ability to connect) and enter password 12345)
 WEP Passphrase: Enter a passphrase and click Generate key to have the access
point generate your encryption key.
WEP Key Format HEX
Character set 0-9 & A-F, a-f only
64-bit key length 10 characters
128-bit key length 26 characters
Selecting WPA-PSK, WPA2-PSK, or WPA-PSK & WPA2-PSK (WPA2-PSK recommended):
The following section outlines options when selecting PSK (Preshared Key Protocol).
 Data Encryption: Select the cipher type to use.
o TKIP: Recommended when using WPA-PSK security.
o AES: Recommended when using WPA2-PSK or WPA-PSK & WPA2-PSK
 WPA Passphrase – Enter the passphrase.
o This is the password or key that is used to connect your computer to this
router wirelessly
Selecting WPA, WPA2, or WPA & WPA2 with Radius:
© Copyright 2015 TRENDnet. All Rights Reserved.
ASCII
Alphanumeric (a,b,C,?,*, /,1,2, etc.)
5 characters
13 characters
The following section outlines options when selecting Radius.
Note: Radius requires an external RADIUS server, PSK only requires you to create a
passphrase.
 Data Encryption: Select the cipher type to use.
o TKIP: Recommended when using WPA-PSK security.
o AES: Recommended when using WPA2-PSK or WPA-PSK & WPA2-PSK
Once you have selected the data encryption type. Click Apply to save settings and go to
the RADIUS Settings section under System button on the left side.
The following section outlines options to configure the access point's RADIUS settings.
 Radius Server: Configure the RADIUS server settings.
o IP: Enter the IP address of the RADIUS server. (e.g. 192.168.10.250)
o Port: Enter the port your RADIUS server is configured to use for RADIUS
authentication.
Note: It is recommended to use port 1812.
TEW-734APO
46