TRENDnet User's Guide
Basic Setting
This page displays thin access points connected in the network.
1. Log into the management page (see
2. Click on Thin AP and Basic Settings.
General Settings
Device Mode: Select the mode you would want the access point to operate on.
Device Name: Enter a device name that can help distinguish each devices
IP Settings
DHCP Client: Select this option to set the access point to obtain DHCP you're your
DHCP server.
Static: Select this option to manually configure the access point's IP address.
o IP Address: Enter the IP address to assign
o Subnet Mask: Enter the subnet mask of the access point
o Gateway IP Address: Enter the gateway IP address
o DNS1-2: Enter the DNS IP address to assign on the access point.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access the management
page" on page 9).
Access Control Mode
LAN: Select when your access controller is connected on your LAN (Local Are
Network).
Internet: Select this option to have your access controller access the access point
via Internet and enter the elect the mode you would want the access point to
operate on.
o Management Port: Enter the port to assign to access the access point via
Internet
o FW Upgrade Port: Enter the port to use when performing upgrade through
the Internet.
VLAN
Enable 802.1 Q VLAN: Select this option to enable VLAN
Management VLAN ID: Enter the VLAN ID to assign the access point.
Information
This page displays thin access points configured information.
1. Log into the management page (see
2. Click on Thin AP and Basic Settings.
TEW-734APO
"Access the management
page" on page 9).
36