Change Your Ip Address - TRENDnet TEW734APO User Manual

TRENDnet User's Guide

Change your IP address

In most cases, you do not need to change the access point's IP address settings.
Typically, the access point IP address settings only needs to be changed, if you plan to
use another access point in your network with the same IP address settings, if you are
connecting the access point to an existing network that is already using the IP address
settings your access point is using.
In addition, the access point can be used as a DHCP (Dynamic Host Configuration
Protocol) server to automatically assign an IP address to each computer or device on
your network. If you already have a DHCP server on your network, or if you do not want
to use the access point as a DHCP server, you can disable this setting. This setting would
be used when the access point's System settings is set to Router mode.
Note: If you are not encountering any issues or are not faced with one of the cases
described above or similar, it is recommended to keep your router IP address settings as
default.
Note: For VPN (Virtual Private Network) configuration, it is required that each router
should have a different router or LAN IP address/network on each end of the VPN tunnel.
Default Router or LAN IP Address: 192.168.10.1 00
Default Router or LAN IP Network: 192.168.10.0 / 255.255.255.0
1. Log into the management page (see
2. Click on System, and click on Network Settings.
© Copyright 2015 TRENDnet. All Rights Reserved.
"Access the management page" on page 9).
 IP Address: Enter the new access point IP address. (e.g. 192.168.100.1)
 Subnet Mask: Enter the new access point subnet mask.(e.g. 255.255.255.0)
 DHCP Server: Enable or Disable the DHCP server on the access point.
 DHCP IP Address Range: Enter the IP address of the DHCP server to assign.
 Lease Time: Enter the lease time in seconds that DHCP client will hold their
automatically assigned IP address before requesting a new IP address
 Enable DHCP Relay: Enable to forward DHCP requests and replies between
clients and servers when they are not on the same physical subnet
 DHCP Server IP: Enter the DHCP IP address of the DHCP Relay
Note: The DHCP address range will change automatically to your new access point's
IP address settings so you do not have to change the DHCP address range manually
to match your new router IP address settings.
3. To save changes, click Apply at the bottom of the page.
Note: If you changed the IP address of the access point you will need to access the
management page using the new IP address (e.g Instead of using the default
http://192.168.10.100 using your new router IP address will use the following format
using your new router IP address http://(new.router.ipaddress.here) to access the
management page.
TEW-734APO
24