TRENDnet User's Guide
4. To save changes, click Apply.
Note: You will need to access your access point management page using your new
access point IP address. (e.g. Instead of using the default
new access point IP address will use the following format using your new IP address
http://(new.ipaddress.here) to access your access point management page. You can
also use the default login URL
http://tew-815DAP
Access Point Maintenance & Monitoring
Reset your Access Point to factory defaults
Administrator > Settings Management
You may want to reset your access point to factory defaults if you are encountering
difficulties with your access point and have attempted all other troubleshooting. Before
you reset your access point to defaults, if possible, you should backup your access point
configuration first, see
"Backup and restore your access point configuration settings"
page 47.
There are two methods that can be used to reset your access point to factory defaults.
• Reset Button – Located on the rear panel of your access point, see
Hardware
Features" on page 2. Use this method if you are encountering
difficulties with accessing your access point management page.
OR
• Access Point Management Page
1. Log into your access point management page (see
management
page" on page 7).
2. Click on Administrator and click on Settings Management.
3. Next to Load Factory Defaults, click Load Default. When prompted to confirm this
action, click OK.
© Copyright 2014 TRENDnet. All Rights Reserved.
http://192.168.10.100
your
on
"Product
"Access your access point
Access Point Default Settings
Administrator User Name
Administrator Password
Access Point Default URL
Access Point IP Address
Access Point Subnet Mask
Mode
Wireless 2.4GHz & 5GHz
Wireless 2.4GHz Network
Name/Encryption
Wireless 2.4GHz & 5GHz Multiple SSID
TEW-815DAP
admin
admin
http://tew-815DAP
192.168.10.100
255.255.255.0
Access Point
Enabled
Please refer to sticker or
device label
Disabled
40