Initialization Mode Selection - Agilent Technologies 1200 Infinity Series User Manual

Initialization mode selection

The following initialization (init) modes are selectable:
Table 25 Initialization Mode Switches
1
Requires firmware B.06.40 or above. Modules without LAN on board, see G1369C LAN Interface Card
Bootp
When the initialization mode Bootp is selected, the module tries to
download the parameters from a Bootp Server. The parameters obtained
become the active parameters immediately. They are not stored to the
non- volatile memory of the module. Therefore, the parameters are lost
with the next power cycle of the module.
Figure 62
Agilent 1200 Infinity Series VWD - User Manual
SW 6 SW 7
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
Bootp (Principle)

Initialization mode selection

SW 8 Init Mode
OFF Bootp
ON Bootp & Store
OFF Using Stored
ON Using Default
OFF 1
DHCP
13
LAN Configuration
201