Leak Detector
Introduction
Introduction
Agilent CrossLab CS Electronic Leak Detector Operation Manual
Figure 1. The Agilent CrossLab CS leak detector front screen buttons.
The Agilent leak detector is controlled with two buttons on the
front of the instrument directly below the screen, as shown in
Figure
1. The functions of these buttons are described in
this section.
Power/Mode button
The Power/Mode button is used to switch the leak detector on
and off, as well as to scroll through and select different
operational modes.
•
To turn on the instrument, briefly press and release the
Power/Mode button.
•
To turn off the instrument, press and hold the Power/Mode
button for three seconds.
•
To scroll through the available modes, when the
instrument is on, briefly press and release the
Power/Mode button.
5