Optimization of the System
The settings used for this analysis are specific for this purpose. For other
applications the system can be optimized in various ways. Please refer to
the section
Preparing the HPLC System
1 Turn on the Agilent ChemStation PC and the monitor.
2 Turn on the modules.
3 Start the Agilent ChemStation software. If the pump, autosampler,
Agilent 1200 Infinity Series VWD - User Manual
"Optimizing the Detector Performance"
thermostatted column compartment and detector are found, the Agilent
ChemStation screen should look like shown in
The System status is red (Not Ready).
Figure 17
Initial Agilent ChemStation screen (Method and Run Control)
Using the Detector
Setting up an Analysis
on page 84.
Figure 17
on page 61.
4
61