Table of Contents
Advertisement
Jacking point positions
G
WARNING
If you do not position the jack correctly at the
appropriate jacking point of the vehicle, the
jack could tip over with the vehicle raised.
There is a risk of injury.
Only position the jack at the appropriate jack-
ing point of the vehicle. The base of the jack
must be positioned vertically, directly under
the jacking point of the vehicle.
G
WARNING
On uphill and downhill slopes, the jack could
tip over with the vehicle raised. There is a
danger of injury.
Do not change wheels on uphill or downhill
gradients. Contact a qualified specialist work-
shop.
!
Only position the jack on the jacking points
intended for this purpose. You could other-
wise damage the vehicle.
Position jack ; at jacking point =.
X
Insert jack crank : into the jack ; and turn
X
until the jack sits completely on the jacking
Changing a wheel
point = and the base of the jack lies evening
on the ground.
Turn jack crank : until the tyre is raised a
X
maximum of 3 cm off the ground.
Loosen and remove the wheel (
X
Removing a wheel
Requirements:
the vehicle is raised (
R
Avoid applying any force to the brake disc when
changing a wheel as this could impair the level of
comfort when braking.
!
Do not place wheel bolts in sand or dirt. The
threads of the wheel bolts and wheel hubs
could otherwise be damaged when the bolts
are tightened.
Unscrew the wheel nuts.
X
Remove the wheel.
X
Fit the new wheel (
X
Y
Fitting a new wheel
Requirements
The wheel is removed (
R
G
WARNING
Oiled or greased wheel bolts or damaged
wheel bolts/hub threads can cause the wheel
bolts to come loose. As a result, you could
lose a wheel while driving. There is a risk of
accident.
Never oil or grease wheel bolts. In the event of
damage to the threads, contact a qualified
specialist workshop immediately. Have the
damaged wheel bolts or hub threads
replaced/renewed. Do not continue driving.
Observe the notes on selecting tyres
X
(
page 215).
Y
On tyres with a specified direction of rotation, an
arrow on the sidewall of the tyre indicates its
correct direction of rotation. Ensure the direc-
tion of rotation is maintained when fitting.
Slide the new wheel onto the wheel hub and
X
push it on.
page 219).
Y
page 218).
Y
page 219).
page 219).
Y
Z
219
Advertisement
Table of Contents
