Table of Contents
Advertisement
Changing a wheel
216
When replacing wheels, make sure to fit the
correct:
designation
R
type
R
When replacing tyres, make sure to fit the
correct:
designation
R
manufacturer
R
type
R
G
WARNING
Exceeding the stated tyre load-bearing capa-
city and the approved maximum speed could
lead to tyre damage or the tyre bursting. There
is a risk of accident.
Therefore, only use tyre types and sizes
approved for your vehicle model. Observe the
tyre load rating and speed rating required for
your vehicle.
!
For safety reasons, Mercedes-Benz recom-
mends that you only use tyres, wheels and
accessories which have been specially
approved by Mercedes-Benz for your vehicle.
These tyres have been specially adapted for
use with the driving safety systems, such as
®
ABS or ESP
.
Only use tyres, wheels or accessories tested
and approved by Mercedes-Benz. Certain
characteristics, e.g. handling, vehicle noise
emissions or fuel consumption, may other-
wise be adversely affected. In addition, when
driving with a load, tyre dimension variations
could cause the tyres to come into contact
with the bodywork and axle components. This
could result in damage to the tyres or the
vehicle.
Mercedes-Benz accepts no liability for dam-
age resulting from the use of tyres, wheels or
accessories other than those tested and
approved.
Further information on wheels, tyres and
approved combinations can be obtained from
any qualified specialist workshop.
!
Retreaded tyres are neither tested nor rec-
ommended by Mercedes-Benz, since previ-
ous damage cannot always be detected on
retreaded tyres. As a result, Mercedes-Benz
cannot guarantee vehicle safety if retreaded
tyres are fitted. Do not fit used tyres if you
have no information about their previous
usage.
!
Large wheels: the lower the section width
for a certain wheel size, the lower the ride
comfort is on poor road surfaces. Roll comfort
and suspension comfort are reduced and the
risk of damage to the wheels and tyres as a
result of driving over obstacles increases.
!
On vehicles fitted with a tyre pressure mon-
itor, electronic components are located in the
wheel.
Tyre-fitting tools should not be applied in the
area of the valve, as this could damage the
electronic components.
Only have tyres changed at a qualified spe-
cialist workshop.
Accessories that are not approved for your vehi-
cle by Mercedes-Benz or are not being used cor-
rectly can impair operating safety.
Before purchasing and using non-approved
accessories, visit a qualified specialist work-
shop and enquire about:
suitability
R
legal stipulations
R
factory recommendations
R
Observe the following when selecting, fitting
and replacing tyres:
Country-specific requirements for tyre
R
approval stipulating a specific tyre type for
your vehicle.
Furthermore, the use of a specific tyre type in
certain regions and areas of operation can be
highly beneficial.
Use only tyres and wheels of the same type,
R
design (summer tyres, winter tyres) and
make.
Always fit tyres of the same size on a given
R
axle (left and right).
In the event of a flat tyre an exception can be
made only for the journey to the specialist
qualified workshop.
Fit only tyres of the correct size onto the
R
wheels.
Modifications to the brake system, wheels
R
and the tyres are not permitted.
The use of spacers or brake dust shields is not
permitted and will invalidate the general oper-
ating permit.
Advertisement
Table of Contents
