Table of Contents
Advertisement
Windscreen wipers and windscreen washer system
Replacing rear light bulbs
Changing tail lamp light bulbs
Tail light/brake lamp (vehicles with halogen
:
headlamps)
;
Turn signal lamp
Reversing lamp
=
Rear foglamp (vehicles with halogen head-
?
lamps)
Requirements:
turn signal lamp: light bulb type WY21 21 W
R
reversing lamp: light bulb type W21W 21 W
R
brake lamp/tail light: light bulb type P21/5W
R
21 W/5 W
rear foglamp: light bulb type H21W 21 W
R
the lighting system is deactivated.
R
Unscrew screws :.
X
Remove the tail lamps carefully.
X
Pull the connector off the bulb holder of the
X
tail lamp.
Turn the corresponding socket anti-clockwise
X
and remove from the bulb holder.
Turn the respective light bulb anti-clockwise,
X
applying slight pressure, and pull it out of the
socket.
Insert the new light bulb into socket and turn
X
it clockwise.
Insert the socket into the bulb holder and turn
X
it clockwise.
Press the connector into the bulb holder of
X
the tail lamp.
Press the tail lamp onto the vehicle.
X
Tighten the screws :.
X
Changing light bulbs in the licence plate
lamp
Requirements
Light bulb type W5W 5 W
R
The lighting system is deactivated.
R
Reach into the opening next to the licence
X
plate lamp : from below.
Turn the socket anti-clockwise and remove it.
X
Pull the light bulb out of the socket.
X
Insert the new light bulb into the socket, so
X
that the base of the lamp is resting fully on the
bottom of the socket.
Insert the socket and turn it clockwise.
X
Windscreen wipers and windscreen
washer system
Switching the front windscreen wip-
ers on and off
!
Do not operate the windscreen wipers when
the windscreen is dry, as this could damage
the wiper blades. Moreover, dust that has col-
lected on the windscreen can scratch the
glass if wiping takes place when the wind-
screen is dry.
85
Z
Advertisement
Table of Contents
