Ashtray and cigarette lighter
76
Before using the lashing eyelets, always make
sure they are properly fitted and cannot be
moved.
Observe the notes on the loading the vehicle
(
page 72).
Y
Also observe the following notes:
when a load is fastened to the lashing eyelets,
R
the angle between the load and the lashing
eyelets must not exceed 45°.
when a load is fastened to the lashing eyelets,
R
the tensile load of 150 daN may not be excee-
ded.
Information on suitable load securing aids, lash-
ing materials and suitable accessories can be
obtained from a qualified specialist workshop.
Fitting lashing eyelets
Turn the bolt connection : anti-clockwise
X
and unscrew it completely.
Insert the lashing eyelet into the guide rail
X
rotated by 90°.
Turn the lashing eyelet 90° clockwise.
X
Slide the lashing eyelet near the load.
X
The nubs on the underside of the lashing eye-
let must be fully seated in the notches of the
guide rail.
Turn the bolt connection : clockwise and
X
tighten it.
Moving the lashing eyelets
Turn the bolt connection : anti-clockwise
X
and unscrew it completely.
Slide the lashing eyelet near the load.
X
The nubs on the underside of the lashing eye-
let must be fully seated in the notches of the
guide rail.
Turn the bolt connection : clockwise and
X
tighten it.
Removing lashing eyelets
Turn the bolt connection : anti-clockwise
X
and unscrew it completely.
Turn the lashing eyelet 90° anti-clockwise.
X
Take the lashing eyelet out of the guide rail.
X
Ashtray and cigarette lighter
Using the ashtray
To insert the ashtray: remove the rubber
X
mat from the stowage space.
Press the ashtray ; into the flat recess in the
X
centre console with slight pressure until it sits
firmly.
To open the ashtray: push the lid : of the
X
ashtray upwards.
To remove the ashtray: push the ashtray ;
X
forwards slightly and lift it up and out.