Table of Contents
Advertisement
Retrofitting a trailer tow hitch is only permissible
if a trailer load is specified in your vehicle docu-
ments.
You can obtain further information on the trailer
tow hitch at a qualified specialist workshop.
Mounting dimensions
!
The distance of the trailer coupling from the
road surface when the vehicle is unladen
depends on the model and equipment fitted
on the vehicle. It is therefore not possible to
give a specific figure.
Observe securing points on the chassis frame
when retrofitting the trailer coupling.
You can obtain further information on retro-
fitting from a qualified specialist workshop.
Trailer tow hitch
:
Securing points
;
Distance from road surface
(350 mm-420 mm, laden)
The distance from the road surface depends on
the vehicle model.
Only use a trailer tow hitch which has been tes-
ted and specially approved by Mercedes-Benz
for your vehicle.
Permissible trailer load
The following values vary and are dependent
upon:
type of vehicle
R
the permissible gross vehicle weight
R
rear axle ratio
R
other possible optional equipment
R
You must therefore observe the entries in the
vehicle documents regarding operation with a
trailer. The relevant permissible values (that
should not be exceeded) can be found there.
This information can also be found on the iden-
tification plates of the trailer tow hitch of the
trailer and the vehicle. If the values differ, the
lowest value applies.
When driving in mountainous areas, note that
the engine power output, and with it the gradient
229
Z
Advertisement
Table of Contents
