Table of Contents
Advertisement
Changing a wheel
220
G
WARNING
If you tighten the wheel bolts or wheel nuts
when the vehicle is raised, the jack could tip
over. There is a risk of injury.
Only tighten the wheel bolts or wheel nuts
when the vehicle is on the ground.
For safety reasons, Mercedes-Benz recom-
X
mends that you only use wheel nuts which
have been approved for Mercedes-Benz vehi-
cles and the respective wheel.
Screw in the wheel nuts and tighten them
X
lightly.
Lower the vehicle (
X
Lowering the vehicle after changing a
wheel
Requirements
The new wheel is fitted (
R
To lower the vehicle: turn the jack crank
X
until the wheels are on the ground.
Tighten the wheel nuts evenly in a diagonal
X
pattern in the order indicated (: to B).
Stipulated tightening torque of steel and
light-alloy wheels: 133 Nm.
G
WARNING
The wheels could work loose if the wheel nuts
and bolts are not tightened to the specified
tightening torque. There is a risk of accident.
Have the tightening torque immediately
checked at a qualified specialist workshop
after a wheel is changed.
page 220).
Y
page 219).
Y
Check the tyre pressure of the newly fitted
X
wheel and adjust it if necessary.
Vehicles with a tyre pressure monitor:
X
restart the tyre pressure monitor
(
page 212).
Y
Exception: the new wheel is an emergency
spare wheel.
Be sure to observe the following further related
subjects:
notes on tyre pressure (
R
page 210)
Y
Advertisement
Table of Contents
