Table of Contents
Advertisement
Online and Internet functions
166
Ending an unintentional emergency call
Press the ~ button on the multifunction
X
steering wheel.
Data transfer to the Mercedes-Benz
emergency call system
The following data is transmitted to the
Mercedes-Benz emergency call centre:
the vehicle's GPS position data
R
the GPS position data of the route (a few
R
hundred metres before the incident)
direction of travel
R
vehicle identification number
R
the drive type of the vehicle
R
whether Mercedes me connect is installed or
R
not
emergency call triggered manually or auto-
R
matically
the time of the accident
R
the language setting in the multimedia sys-
R
tem
For accident clarification purposes, the follow-
ing measures can be taken up to an hour after
the emergency call has been triggered:
the current position of the vehicle can be
R
called up.
a voice connection can be established to the
R
vehicle occupants.
Online and Internet functions
Internet connection
Internet connection restrictions
G
WARNING
If you operate information and communica-
tion equipment integrated in the vehicle when
driving, you could be distracted from the traf-
fic situation. This could also cause you to lose
control of the vehicle. There is a risk of an
accident.
Only operate this equipment when the traffic
situation permits. If you cannot be sure of this,
stop the vehicle paying attention to road and
traffic conditions and operate the equipment
with the vehicle stationary.
When operating the multimedia system, you
must observe the legal requirements of the
country you are currently in.
Depending on the vehicle equipment, there are
the following options for establishing an Internet
connection:
®
via Bluetooth
with a data-enabled mobile
R
phone (
page 150)
Y
COMAND Online: via USB (
R
Use of the Internet functions is restricted while
the vehicle is in motion.
Setting up the Internet connection via
®
Bluetooth
and USB
Requirements for connecting via Bluetooth
Connect a mobile phone to the multimedia
R
system via Bluetooth
If you use the telephone module for Internet
R
functions, you require a SIM card in the tele-
phone module or a Bluetooth
mobile phone.
COMAND Online: requirements for connect-
ing via USB
Connect a mobile phone to the multimedia
R
system via USB (
page 175).
Y
If you use the telephone module for Internet
R
functions, you require a SIM card in the tele-
phone module or a Bluetooth
mobile phone.
To connect via Bluetooth
must support one of the following Bluetooth
profiles:
DUN (Dial-Up Networking)
R
PAN (Personal Area Network)
R
®
To connect via USB
in vehicles with COMAND
Online, the mobile phone must support one of
the following USB classes:
RNDIS (Remote Network Driver Interface
R
Specification)
CDC/NCM (Network Control Model)
R
CDC/ECM (Ethernet Control Model)
R
CDC/ACM (Access Control Model)
R
The Internet connection can be restricted or
may not function in the following cases:
the mobile phone is switched off.
R
there is insufficient two-way radio network
R
coverage.
use of the mobile phone data is deactivated.
R
page 175)
Y
®
(
page 150).
Y
®
SAP-capable
®
SAP-capable
®
, the mobile phone
®
®
Advertisement
Table of Contents
