Emergency Call - NEC UNIVERGE DT930 User Manual


After a third attempt (if incorrect
password is entered three times
consecutively), the following error
message is displayed.

Security Mode is continued by
pressing or Soft key (OK).

After 10 minutes later and press
any key, the password entry
screen is displayed.

EMERGENCY CALL

It is required to cancel the Security Mode before
making a call. But the emergency call is allowed
without canceling the Security Mode. Maximum 3
emergency numbers can be registered by system
data setting at initial installation.
This feature is not available when
"Security Mode" is not activated or no
emergency number is set by system
data setting at initial installation. For
details, please contact the system
administrator.
1.
Security lamp lights red and "Security Lock" is
displayed.
2.
Lift the handset.
"Dial Emergency Number Only." is
displayed.
When you press Speaker key,
password entry screen is displayed.
The emergency call screen is
displayed by lifting the handset.
Emergency call cannot be made with
Speaker key.
3.
Dial the emergency number.
Example: Dial "911"
Maximum 3 emergency numbers are
set by system data setting at initial
installation. For details, please contact
the system administrator.
The user can make a call to only the
predetermined number. When numbers
other than the predetermined
emergency number are dialed, the
following message appears.
After a few seconds, the display goes
back to emergency call screen.
4.
The call is originated to the dialed emergency
number.
You will receive a ring back tone.
5.
After a conversation, replace the handset.
After making a call to emergency
number, security lock is released, since
there is a case the terminal receives a
call back from the emergency number.
The security lock will be set after 60
minutes from releasing Security Mode.
81
FEATURE OPERATION