Feature Operation; Login/Logout; To Login; To Logout - NEC UNIVERGE DT930 User Manual

FEATURE OPERATION

This chapter describes how to login/logout, how
to input characters and how to make a call/hold,
etc.

LOGIN/LOGOUT

TO LOGIN

When login mode is activated, the terminal prompts
for Login ID and Password. When the terminal
starts up with displaying the below screen, the
Login Mode is activated.
1.
The terminal is starting up with Login Mode.
2.
Enter Login ID.
As initial setting, enter the extension
number as Login ID.
Up to 16 characters can be entered for
Login ID.

After entering Login ID, press Soft key
(Set).
3.
Enter a password.
As initial setting, enter the extension
number as password.
From 4 to 10 characters can be
entered password displayed in "*".

After entering Login ID, press Soft key
(OK).
4.
If the Login ID and Password are accepted,
display changes to normal idle status.
The terminal becomes available.
If you enter the wrong ID and/or
password, normal screen is not
displayed and return to [Login] screen.
In this case enter the correct "Login
ID" and "Password
Depends on settings, other than the
Favorite screen might be displayed.
For details, please refer to
WHEN THE PHONE

TO LOGOUT

The terminal which is operated with Login Mode can
log out. Logout operation is as follows.
1.
Press Speaker key
You will receive a dial tone.
Speaker key lamp lights red.
2.
Press Logout feature key.
Logout feature key can be set by
means of system data setting. For
details, please contact the system
administrator.
After Logout feature key is pressed, the
terminal is logged out within 10
seconds.
58
FEATURE OPERATION
"SCREEN
STARTS".